Pressing Instructions

You need a commercial heat press to properly press our transfers. Presses like the Cricut EasyPress, home irons, HTVRont etc. will not allow you to adjust the pressure, which can cause your transfer to not adhere properly to the garment. We recommend checking the temperature of your heat press before pressing. Presses can run hotter or colder than the press display temp shows. You may need to adjust the temp slightly to ensure you are pressing at the correct temperature. 

 

DTF Hot Peel Transfers

Pre-press the garment for 5 seconds to remove any moisture

Temp: 315ºF

Press Time: 8 - 10 seconds

Pressure: HEAVY (if print doesn't stick, this is likely the biggest reason why.  Make sure your press is on heavy pressure!)

Peel: Hot

*We recommend giving the garment one more press for 5 seconds or so with a piece of parchment paper or Teflon on top, after you remove the transfer backing. This will mattify the design and really make sure it has pressed into the fibers well.

 

Single Color Screen Print Transfers (White backing paper)

Pre-press the garment for 5 seconds to remove any moisture

Temp: 325ºF

Press Time: 8 - 10 seconds

Pressure: HEAVY (if print doesn't stick, this is likely the biggest reason why.  Make sure your press is on heavy pressure!) 

Do not cover with a Teflon sheet or parchment paper

Peel: Hot

*We recommend giving the garment one more press for 5 seconds or so with a piece of parchment paper or Teflon on top, after you remove the transfer backing. This will mattify the design and really make sure it has pressed into the fibers well. 

 

Chenille & Sequin Patches

Pre-press the garment for 5 seconds to remove any moisture

Lay patch on garment and cover with a Teflon sheet or parchment paper.

Temp: 325ºF

Pressure: HEAVY (if patch doesn't stick, this is likely the biggest reason why.  Make sure your press is on heavy pressure!)

Press for 15 seconds. 

Turn garment inside out and press another 15 seconds.

Do not wash or dry with fabric softener. Wash garment inside out. Hang Dry.

 

Puff Screen Print Transfers

Pre-press the garment for 5 seconds to remove any moisture

Temp: 350ºF

Press Time: 7 seconds

Pressure: HEAVY (if print doesn't stick, this is likely the biggest reason why.  Make sure your press is on heavy pressure!)

Peel: Hot

 

UVDTF Wraps

No heat needed for UV DTF :)

1. Peel design transfer off of backing.

2. Place the transfer on the cup ensuring design is straight and positioned correctly.

(The adhesive is very strong. Once the transfer touches the glass it's impossible to take off)

3. Press the transfer down, working from the center outwards, pushing out any bubbles.

4. Rub all over the design with your fingers.  The more rubbing the better.

5. Peel clear film off and you're done!

Hand wash only.  We do not advise to put in dishwasher or microwave.

We are not responsible for application mishaps.

*Please note:  Not all brands of 16 oz. glass cups have the exact same measurements. They can differ by a couple of millimeters. Our wraps have been measured to fit Libbey glass cans. Adjustments may be necessary*